Allied-telesis SwitchBlade x8106 Manuel d'utilisateur télécharger pdf (Page 75)

SwitchBlade x8106 Chassis Switch Installation Guide

3. Identify the lowest 1/2” screw hole pattern on the rack mounting rails

within the space reserved for the AT-SBx8106 Chassis.

4. Install one rack mount screw in each vertical rail, at the same height in

the top screw hole of the lowest 1/2” hole pattern, as shown in

Figure 30. Do not fully tighten the screws at this time. The screw heads

should protrude from the rack approximately 6.4 mm (.25 in). The

screws are used to support the chassis while you secure it to the rack.

Figure 30. Rack Mounting Hole Locations

5. After installing the two screws in the equipment rack, go to “Unpacking

the AT-SBx8106 Chassis” on page 76.

6.4 mm (.25 in)

Screw head

Top screw hole of the lowest 1/2” hole pattern

away from rack

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 239 240

Pas de commentaire

Allied-telesis SwitchBlade x8106 Manuel d'utilisateur Page 75