Allied-telesis SwitchBlade x8106 Manuel d'utilisateur télécharger pdf (Page 175)

SwitchBlade x8106 Chassis Switch Installation Guide

175

Figure 131. Connecting the Negative Lead Wire

Allied Telesis recommends tightening the screw to 30 to 40 inch-lbs.

Warning

Check to see if there are any exposed copper strands coming from

the installed wires. When this installation is done correctly there

should be no exposed copper wire strands extending from the

terminal block. Any exposed wiring can conduct harmful levels of

electricity to persons touching the wires.  E12

6. Slide the plastic cover to the left and lightly tighten the two screws with

a #1 Phillips-head screwdriver to secure the cover. See Figure 120 on

page 165. You might need to slightly lift the locking handle to access

the bottom screw.

Caution

Do not over tighten the screws or you may crack or break the plastic

cover.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 239 240

Pas de commentaire

Allied-telesis SwitchBlade x8106 Manuel d'utilisateur Page 175