Allied-telesis AT-S95 CLI Manuel d'utilisateur télécharger pdf (Page 96)

Page 84

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

description

The description Interface Configuration (Ethernet, port-channel) mode command adds a description to an

interface. Use the no form of this command to remove the description.

Syntax

description string

no description

Parameters

•

string — Comment or a description of the port to enable the user to remember what is attached to the port.

(Range: 1-64 characters)

Default Configuration

The interface does not have a description.

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example adds a description to Ethernet port 1/g5.

speed

The speed Interface Configuration (Ethernet, port-channel) mode command configures the speed of a given

Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the default

configuration.

Syntax

speed {10 | 100 | 1000}

no speed

Parameters

•

10 — Forces10 Mbps operation.

• 100 — Forces 100 Mbps operation.

• 1000 — Forces 1000 Mbps operation.

Default Configuration

Maximum port capability

Console(config)#

interface ethernet 1/g5

Console(config-if)#

description

"RD SW#3"

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 347 348

Pas de commentaire

Allied-telesis AT-S95 CLI Manuel d'utilisateur Page 96