Allied-telesis AT-IX5-28GPX Manuel d'utilisateur télécharger pdf (Page 64)

Chapter 4: Installing the Switch and its Power Supplies

3. Align the edges of the power supply module with the guides in the slot

and carefully slide the module into the chassis until it is flush with the

rear panel of the chassis, as shown below. Light pressure may be

needed to seat the module on the connector on the rear panel of the

chassis.

Caution

Do not force the power supply module into place. Doing so may

damage the connector pins on the backplane inside the chassis. If

there is resistance, remove the module and reinsert it after verifying

that the edges of the card are properly aligned in the guides in the

chassis’ module slot.

Figure 20. Installing the AT-PWR800 Power Supply Module

2261

100

-240VAC~ 12A MAX

C PWR

AT-PWR8000

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 128 129

Pas de commentaire

Allied-telesis AT-IX5-28GPX Manuel d'utilisateur Page 64