Allied-telesis AT-IX5-28GPX Manuel d'utilisateur télécharger pdf (Page 35)

IX5-28GPX Installation Guide

The switch displays the letter “F” for fault on the ID LED if it encounters

one of the following problems:

 A cooling fan has failed.

 An unsupported power supply module has been installed.

 One of the power supplies has failed.

 The internal temperature of the switch has exceeded the normal

operating range and the switch may shut down.

Note

You can use the SHOW SYSTEM ENVIRONMENT command in the

command line interface to identify the source of the problem.

The states of the LED when the switch is operating in the low power mode

are shown in Figure 8.

Figure 8. Switch ID LEDs in the Low Power Mode

The switch is the master switch of a VCStack.

The switch is operating as a stand-alone unit.

The switch is a member switch of a VCStack.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 128 129

Pas de commentaire

Allied-telesis AT-IX5-28GPX Manuel d'utilisateur Page 35