Allied-telesis AT-IX5-28GPX Manuel d'utilisateur télécharger pdf (Page 113)

IX5-28GPX Installation Guide

113

To install an SFP or SFP+ transceiver, perform the following procedure:

1. Remove the dust plug from a transceiver slot on the switch.

Figure 64 on page 113 shows the dust plug being removed from a port.

Figure 64. Removing the Dust Plug from an SFP+ Slot

Note

When VCStack is enabled on the switch, slots S1/27 and S2/28 are

reserved as stacking ports and may not be used for regular SFP or

SFP+ transceivers.

2. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

3. If you are installing the transceiver in a top slot, position the transceiver

with the Allied Telesis label facing up. If you are installing the

transceiver in a bottom slot, position the transceiver with the label

facing down.

S2/28

S1/2

CON

SFP+

2675

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 128 129

Pas de commentaire

Allied-telesis AT-IX5-28GPX Manuel d'utilisateur Page 113