Allied-telesis AT-S99 Manuel d'utilisateur télécharger pdf (Page 131)

AT-S73 and AT-S99 Management Software User’s Guide

131

FIBER PORT or COPPER PORT

ST This column displays the states of the ports. The possible states are:

 * - The port has establish a link to a network device.

 o - The port has not establish a link to a network device.

SP This column displays the speeds of the ports. The possible speeds

are:

 10 - 10 Mbps

 100 - 100 Mbps

 1G - 1 Gbps

FC This column displays the status of flow control on the ports of the

AT-CM Line Cards. The possible states are:

 Y - Flow control is enabled on the port.

 N - Flow control is disabled on the port.

IngRL This column displays the settings of the ingress rate limiting filters

on the ports on the AT-CM Line Cards. The value “0” means rate

limiting has not been set on the port. This is the default setting. For

instructions on setting this parameter, refer to “Configuring the Port

Parameters on AT-CM Line Cards” on page 139. This feature is not

supported on the AT-CV Line Cards.

EgrRL This column displays the settings of the egress rate limiting filters on

the ports on the AT-CM Line Cards. The value “0” means rate

limiting has not been set on the port. This is the default setting. For

instructions on setting this parameter, refer to “Configuring the Port

Parameters on AT-CM Line Cards” on page 139. This feature is not

supported on the AT-CV Line Cards.

OAM This column applies only to AT-CM Line Cards operating in the OAM

visible or the OAM bypass mode. It displays the following OAM

client information:

Table 13. Module Status and Configuration Menu

Column Description

*00

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 319 320

Pas de commentaire

Allied-telesis AT-S99 Manuel d'utilisateur Page 131