Allied-telesis AT-FS705LE Manuel d'utilisateur télécharger pdf (Page 33)

AT-FS705LE Installation Guide

Warning

The power cord is used as a

disconnection device. To de-energize

equipment, disconnect the power cord.

 5

6. Verify that either the PWR LED is green. If

the LED is OFF, refer to “Troubleshooting” on

page 27 for instructions.

Note

The switch perform a self-diagnostic test

upon power up. This takes about 20

seconds to complete.

7. Power ON the end-nodes connected to the

switch.

8. Check that all the LINK/ACT LEDs are

green. If any of the LEDs is OFF, refer to

“Troubleshooting” on page 27 for

instructions.

The switch is now ready for use.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 59 60

Pas de commentaire

Allied-telesis AT-FS705LE Manuel d'utilisateur Page 33