Allied-telesis AT-FS705LE Manuel d'utilisateur télécharger pdf (Page 32)

Installation

Note

You can use either Port 5 or the Uplink

port, but you cannot use both

simultaneously.

When connecting a twisted pair cable to a

port, observe the following guidelines:

• An RJ-45 connector should fit snugly into

the port on the switch. The tab on the con-

nector should lock the connector into place.

• You should check to be sure that you are

using the appropriate type of twisted pair

cabling. Refer to Table 4 on page 10 for

twisted pair cable specifications.

• Since the twisted pair port, when operating

in Auto-Negotiation, is Auto MDI/MDI-X,

you can use either a straight-through or

crossover twisted pair cable to connect any

type of network device to a port on the

switch. If you disable Auto-Negotiation on

the port, the port defaults to MDI-X.

5. Apply power to the switch by plugging the

AC/DC power adapter into an AC power

outlet, the plug the DC connector to the power

receptable of the switch.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Pas de commentaire

Allied-telesis AT-FS705LE Manuel d'utilisateur Page 32