Allied-telesis AT-FS705LE Manuel d'utilisateur

AT-FS705LEFast Ethernet SwitchInstallation GuidePN 613-50138-00 Rev D

Welcome to Allied TelesynxCautionCautions informs you that performing or omitting a specific action may result in equipment damage or loss of data.War

AT-FS705LE Installation GuidexiContacting Allied Telesyn This section provides Allied Telesyn contact information for technical support as well as sal

Welcome to Allied TelesynxiiTo obtain a RMA number, contact Allied Telesyn’s Technical Support at our web site: http://www.alliedtelesyn.com.For Sales

1Chapter 1OverviewThe AT-FS705LE Fast Ethernet Switch is a 10Base-T/100Base-TX unmanaged switch. The switch provides you with a simple, cost-effective

Overview2Figure 2 AT-FS705LE Back PanelKey FeaturesThe AT-FS705LE switch has the following features:❑ Non-blocking architecture❑ Five Auto-Negotiatin

AT-FS705LE Installation Guide3Physical DescriptionThe physical description for the switch includes:❑ Ports 1 through 4❑ Port 5 and the Uplink port❑ LE

Overview4NoteIn order for a twisted pair port on the AT-FS705LE switch to successfully Auto-Negotiate its duplex mode with an end-node, the end-node s

AT-FS705LE Installation Guide5Both Port 5 and the Uplink port offer 10 Mbps or 100 Mbps performance and Auto-Negotiation operation for both speed and

Overview6Auto MDI/MDI-XAn RJ-45 twisted pair port on a 10 Mbps or 100 Mbps Ethernet network device can have one of two possible wiring configurations:

AT-FS705LE Installation Guide7The AT-FS705LE switch features auto MDI/MDI/X on all ports. Auto MDI/MDI-X automatically determines the configuration o

Copyright © 2003 Allied Telesyn, Inc.960 Stewart Drive, Suite B, Sunnyvale, CA 94085, USAAll rights reserved. No part of this publication may be repro

Overview8Each twisted pair port on the AT-FS705LE switch can operate in either half-duplex or full-duplex mode. Since these twisted pair ports are IE

AT-FS705LE Installation Guide9MAC Address TableThe heart of an Ethernet switch is the Media Access Control (MAC) address table. Every device that you

Overview10The switch also checks the destination MAC address of each frame it receives. The destination address is the MAC address of the end-node to

AT-FS705LE Installation Guide11from the table if it does not see a frame from the end-node with the address on any port after five minutes (300 second

Overview12Network TopologiesThe AT-FS705LE switch can be used in a variety of network topologies, such as standalone or back-to-back. Both topologie

AT-FS705LE Installation Guide13Back-to-Back TopologyFigure 4 illustrates a network of two AT-FS705LE switches that have been interconnected using one

15Chapter 2InstallationThis section contains the procedures for installing the switch.Verifying the Package ContentsMake sure the following items are

Installation16NoteFor wall-mount installation, the screws, plastic anchors, and any other material necessary to physically mount the switch to the wal

AT-FS705LE Installation Guide17Observe the following cabling specifications:Reviewing Safety GuidelinesPlease review the following safety guidelines b

iiiElectrical Safety and Emission Compliance StatementStandards: This product meets the following standards.U.S. Federal Communications CommissionDecl

Installation18CautionAir vents: The air vents must not be blocked on the unit and must have free access to the room ambient air for cooling.  7Cautio

AT-FS705LE Installation Guide19Installing the Switch on a Table or DesktopTo install the switch on a table or desktop, perform the following procedure

Installation20NoteYou can use either Port 5 or the Uplink port, but you cannot use both simultaneously.When connecting a twisted pair cable to a port,

AT-FS705LE Installation Guide21WarningThe power cord is used as a disconnection device. To de-energize equipment, disconnect the power cord.  56. Ver

Installation22Wall-Mounting the SwitchThe switch can be mounted vertically or horizontally on a wall using the keyholes on the bottom of the switch.

AT-FS705LE Installation Guide234. Position the switch onto the wall screws, as illustrated in .Figure 3 Positioning the Switch Onto the Wall Screws5.

Installation24• You should check to be sure that you are using the appropriate type of twisted pair cabling. Refer to Table 4 on page 10 for twisted

AT-FS705LE Installation Guide25NoteThe switch perform a self-diagnostic test upon power up. This takes about 20 seconds to complete.8. Power ON the e

Installation26Warranty RegistrationWhen you have finished installing the product, register your product by completing the enclosed warranty card and s

27Chapter 3TroubleshootingFollow the guidelines below to test and troubleshoot the installation in the event a problem occurs.If the PWR LED is OFF, d

ivRFI Emission FCC Class B EN55022 Class B VCCI Class BC-TICK  1Warning: In a domestic environment this product may cause radio interference in which

Troubleshooting28If the LINK/ACT LED is OFF, do the following:❑ Check to be sure that the end-node connected to the port on the switch is powered ON.

29Appendix ATechnical SpecificationsPhysicalDimensions: W x D x H100 x 78.5 x 26 mm (3.93 x 3.09 x 1.02 in)EnvironmentalTemperatureMaximum Operating:

Technical Specifications30Electrical RatingInput Supply Voltage: 7.5VPower Current: 1A MaximumPower Consumption: 8W MaximumStandards & ComplianceI

AT-FS705LE Installation Guide31Pinout AssignmentsFigure 5 shows the pinout assignments for the RJ-45 connector.Figure 1 RJ-45 Pin AssignmentsTable 5

33Appendix BTranslated Safety and Emission Information Important: This appendix contains multiple-language translations for the safety statements in t

Translated Safety and Emission Information34Viktig: Dette tillegget inneholder oversettelser til flere språk av sikkerhetsinformasjonen i denne veiled

AT-FS705LE Installation Guide35Standards: This product meets the following standards: U.S. Federal Communications CommissionDeclaration Of ConformityM

Translated Safety and Emission Information361 RFI Emissions FCC Class B EN55022 Class B VCCI Class BC-TICK 2 Warning: In a domestic environment this

AT-FS705LE Installation Guide37 10 Europe - EU: Use TÜV licensed AC adapter of DC 7.5V, 1A. USA/Canada: Use a UL Listed/CSA Certified AC adapter of D

vImportant: Appendix A contains translated safety statements for installing this equipment. When you see the , go to Appendix A for the translated sa

Translated Safety and Emission Information38Normen: Dieses Produkt erfüllt die Anforderungen der nachfolgenden Normen. 1 Hochfrequenzstörung FCC Klas

AT-FS705LE Installation Guide39Standarder: Dette produkt tilfredsstiller de følgende standarder. 1 Radiofrekvens forstyrrelsesemission: FCC Klasse B

Translated Safety and Emission Information40Eisen: Dit product voldoet aan de volgende eisen. 1 RFI Emissie FCC Klasse B EN55022 Klasse B VCCI Klass

AT-FS705LE Installation Guide41Normes: ce produit est conforme aux normes de suivantes. 1 Emission d’interférences radioélectriques FCC Classe B EN5

Translated Safety and Emission Information42Standardit: Tämä tuote on seuraavien standardien mukainen. 1 Radioaaltojen häirintä FCC Luokka B EN55022

AT-FS705LE Installation Guide43Standard: Questo prodotto è conforme ai seguenti standard. 1 Emissione RFI (interferenza di radiofrequenza) FCC Class

Translated Safety and Emission Information44Sikkerhetsnormer: Dette produktet tilfredsstiller følgende sikkerhetsnormer. 1 RFI stråling FCC Klasse B

AT-FS705LE Installation Guide45Padrões: Este produto atende aos seguintes padrões. 1 Emissão de interferência de radiofrequência FCC Classe B EN550

Translated Safety and Emission Information46Estándares: Este producto cumple con los siguientes estándares. 1 Emisión RFI FCC Clase B EN55022 Clase

AT-FS705LE Installation Guide47Standarder: Denna produkt uppfyller följande standarder. 1 Radiostörning FCC Klass B EN55022 Klass B VCCI Klass BC-TI

viImportante: El Apéndice A contiene mensajes de seguridad traducidos para la instalación de este equipo. Cuando vea el símbolo , vaya al Apéndice

viiTable of ContentsElectrical Safety and Emission Compliance Statement ...iiiTable of Contents...

Table of ContentsviiiStandalone Topology ... 12Back-to-Back Topology... 13Chapter 2Installation .

ixWelcome to Allied TelesynThis guide contains instructions on how to install the AT-FS705LE Fast Ethernet Switch. Where to Find Related GuidesThe All