Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur Page 80

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 222
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 79
Chapter 3: Installing the Chassis in an Equipment Rack
80
Figure 34. Reserving Vertical Rack Space
3. Identify the lowest 1/2” screw hole pattern on the rack mounting rails
within the space reserved for the AT-SBx3112 Chassis.
4. Install one rack mount screw in each vertical rail, at the same height in
the top screw hole of the lowest 1/2” hole pattern, as shown in Figure
35 on page 81. The screws are used to support the chassis while you
secure it to the rack. Do not fully tighten these two screws at this time.
The screw heads should protrude from the rack approximately 6.4 mm
(.25 in).
311.1 mm (12.25“)
152.4 mm (6”0)
463.5 mm (18.25”)
Vue de la page 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 221 222

Commentaires sur ces manuels

Pas de commentaire