Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur télécharger pdf (Page 146)

Chapter 6: Installing the Transceivers and Cabling the Ports

146

4. Install the other end of the cable into an SFP+ slot on another network

device.

5. Repeat this procedure to install additional AT-SP10TW Cables.

Note

To remove the connector and cable from the SFP+ slot, gently push

on the connector, pull on the release tab, and then slide the

connector from the slot.

After installing the AT-SP10TW Cables in the AT-SBx31XS6 Line Card, do

one of the following:

 To install and cable additional transceivers, go to the appropriate

section in this chapter for instructions.

 After cabling all the ports in the chassis, go to Chapter 7,

“Powering On the Chassis” on page 153.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 221 222

Pas de commentaire

Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur Page 146