Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur télécharger pdf (Page 166)

Chapter 7: Powering On the Chassis

166

Connecting the

Grounding Wire

with Bare Wire

To attach the grounding wire to the power supply with bare wire, perform

the following procedure:

1. Prepare an adequate length of solid or stranded 10 AWG grounding

wire by stripping it as shown in Figure 120.

Figure 120. Stripping the solid or Stranded Grounding Wire

2. Use an 8 mm wrench to remove the grounding post nut and washer,

shown in Figure 118 on page 164, from the grounding post on the

power supply.

3. Wrap the grounding wire clockwise around the base of the grounding

post, as shown in Figure 121.

Figure 121. Attaching the Bare Grounding Wire to the Grounding Post

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 221 222

Pas de commentaire

Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur Page 166