Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur télécharger pdf (Page 176)

Chapter 7: Powering On the Chassis

176

3. Using a #1 Phillips-head screwdriver, remove the two screws that

secure the plastic cover over the positive and negative terminals and

remove the plastic cover from the power supply, as shown in

Figure 134. You may need to lift the locking handle slightly to access

the bottom screw.

Figure 134. Removing the Plastic Cover

Note

The plastic cover is not used with the right angle terminals.

4. Use a #3 Phillips-head screwdriver to remove the two screws from the

positive and negative terminals, as shown in Figure 135 on page 177.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 221 222

Pas de commentaire

Allied Telesis Switch AT-SBXPWRSYS1 Manuel d'utilisateur Page 176