Allied Telesis AT-A15/LX Guide d'installation télécharger pdf (Page 20)

Hardware Description

Stacking Module Expansion Slot

The stacking module expansion slot on the back panel of the switch

is for the optional AT-Stack8 Stacking Matrix Module. This module

allows you build a logical switch of up to eight switches.

Stack ID Switch

Next to the stacking ports on the back panel of the switch is the Stack

ID switch (shown in Figure 1-8). You use this switch when you build a

stack to assign each switch a unique identification number.

Figure 1-8 Stack ID Switch

Note

While the Stack ID switch has the range of settings of 0 to 9, only

settings 1 through 8 are valid settings. Settings of 0 and 9 are

invalid and should not be used. For information on setting this

switch, refer to Chapter 3, Installing the Switch.

IS-A IS-B

STACK ID

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 91 92

Pas de commentaire

Allied Telesis AT-A15/LX Guide d'installation Page 20