Allied Telesis AT-iMG7x6MOD series Manuel d'installation télécharger pdf (Page 23)

AT-iMG746MOD Installation Guide

Chapter 3: Installing the Gateway in the Enclosure 23

Connecting the Telephone Wires

To connect the telephone wires, perform the following procedure:

1. Remove the grommet from the telephone wire/ LAN entrance.

2. Connect the telephone wires to each pair of telephone terminal posts in the enclosure, as well as the

appropriate RJ-11 connectors, as shown in Figure 14, at 5.3 in-lbs.

Figure 14. Connecting the Telephone Wires

3. Perform the next steps based on the following:

a. If you are connecting the LAN cable, go to the next subsection, “Connecting the LAN Cables”

on page 24

b. If you are not connecting the LAN cable continue to the next step below.

4. Cut a notch into the bottom of the grommet to accommodate the telephone cable.

5. Secure the telephone wire to the entrance with a UV-rated wire tie (not provided).

6. Trim the wire tie, reinsert the grommet, and seal the grommet with tape and silicone sealant.

Caution

The grommet must be sealed so that the unit can operate correctly in an outside environment.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 55 56

Pas de commentaire

Allied Telesis AT-iMG7x6MOD series Manuel d'installation Page 23