Allied Telesis AT-iMG7x6MOD series Manuel d'installation télécharger pdf (Page 15)

AT-iMG746MOD Installation Guide

Chapter 3: Installing the Gateway in the Enclosure 15

Chapter 3

Installing the Gateway in the

Enclosure

This chapter describes how to install the gateway in the enclosure and assumes you have already installed the

enclosure. Refer to the (Enclosure installation Guide)

Required Tools and Supplies

The following tools and supplies are required to install the gateway:

Tools

Have the following tools on hand before you install the enclosure or gateway:

 Flat head and #2 Phillips screwdrivers

 Wire cutters

 5/32 in. hex-pin security screwdriver

Additional Supplies

You may also need the following supplies:

 Silicone sealant

 Tw o U V- r a t e d w i r e t i e s

 Console cable

 Power cable (AT-iMG646MOD-C01) - or customer built

 Power supply (AT-iMG008, AT-iMG008G)

 Fiber cleaning materials (see Appendix B, “Cleaning Fiber Optic Connectors” on page 51)

Check Package Contents

The following items are included in the electronics package. If any item is missing or damaged, contact your

Allied Telesis representative for assistance.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Pas de commentaire

Allied Telesis AT-iMG7x6MOD series Manuel d'installation Page 15