Allied-telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT Manuel d'utilisateur télécharger pdf (Page 94)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Note - The current firmware version does not allow the following parameters to be

configured:

• Max VPC

• Max VCC

• Max Active VPI Bits

• Max Active VCI Bits

• ILMI VPI

• ILMI VCI

• Neighbor IP Address

• Neighbor Name

Attempting to configure these parameters will result in the error message: "The error

occurred with 'Set' operation. Error: gen Error."

Interface DS3 PLCP

Displays DS3 PLCP configuration and state parameters.

Note - The Interface DS3 PLCP sub-menu option does not display the correct parameters.

Instead, it displays the sub-menu option name as a parameter with a value of 'noSuchName'.

Interface TC Sublayer

Displays TC Sublayer configuration and state parameters.

Note - The Interface TC Sublayer sub-menu option does not display the correct parameters.

Instead, it displays the sub-menu option name as a parameter with a value of 'noSuchName'.

Traffic Descriptor

Displays information on the ATM traffic descriptor type and its associated parameters.

Note - The current firmware version does not allow the following parameters to be

configured:

• Type

• Parameter 1

• Parameter 2

• Parameter 3

• Parameter 4

• Parameter 5

• QoS Class

• Status

Attempting to configure these parameters will result in the error message: "The error

occurred with 'Set' operation. Error: gen Error."

Virtual Path Link (VPL)

PN 613-50507-00 Rev D Page 94 of 253

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 252 253

Pas de commentaire

Allied-telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT Manuel d'utilisateur Page 94