Allied-telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT Manuel d'utilisateur télécharger pdf (Page 240)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Aging Time Info

Displays information about the aging time status, mode, and value.

Note - AT-RG613xx : The Aging Time Value parameter has a fixed value of 0 and cannot be

modified.

Note - AT-RG656BD: The current firmware version does not allow the Learning Status

parameter to be set to 'disable'. Attempting to do so will result in the error message: "The

error occurred with 'Set' operation. Error: time out occurred."

Note - AT-RG656BD : Changing the value of the Aging Time Mode parameter causes the

Aging Time Value parameter to be set to 0.

Note - AT-RG656BD : Valid MIB Set values for the Aging Time Value parameter are in the

range [0-2147483647] inclusive. However, the current firmware version truncates entered

values to 7 digits.

Traffic Priority

Displays the system base priority.

Routing Limit

Displays the routing limit.

Note - Setting the Routing Limit parameter to a value other than 'none' will cause the Base

Priority parameter under Bridge -> Traffic Priority to be set to 0.

Note - When setting the Routing Limit parameter to a value other than 'none', the current

firmware is able to set the parameter successfully for the CLI but not for SNMP. As a result,

AT-View Plus Device Manager will continue to display the value 'none'

QoS Info

Displays Differentiated Service Code Point (DSCP) entries and its QoS priority level.

IGMP Menu

From the IGMP menu, you can view and edit information related to Internet Group Management

Protocol (IGMP).

Leave Time

Displays RTC status information including current time, offset, last update, and last delta.

PN 613-50507-00 Rev D Page 240 of 253

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 252 253

Pas de commentaire

Allied-telesis AT-VIEW PLUS 2.4 DEVICE MANAGEMENT Manuel d'utilisateur Page 240