Allied-telesis AT-S63 Manuel d'utilisateur télécharger pdf (Page 263)

100

101

AT-S63 Management Software Command Line Interface User’s Guide

Section II: Advanced Operations 263

severity Saves events of a particular severity.

Choices are I for Informational, E for Error,

W for Warning, and D for Debug. You can

select more than one severity at a time (for

example, E,W). For a definition of the

severity levels, see Table 10, “Event Log

Severity Levels” on page 271. The default

is E, W, I.

overwrite Overwrites the file if it already exists. Without this

option, the command displays an error if a file with the

same name already exists in the switch’s file system.

Description

This command saves the current entries in an event log to a file in the file

system. The parameters in the command allow you to specify which

events you want saved in the log file.

Examples

The following command saves the event messages stored in the

permanent event log to a file called “switch2.log”. Because the MODULE

and SEVERITY parameters are not included in the command, the defaults

are used, which is events from all modules with an informational, error, or

warning severity level:

save log=permanent filename=switch2.log

The following command saves the error messages of the VLAN module

stored in the temporary event log in a file called “sw14.log.”:

save log=temporary filename=sw14.log module=vlan severity=e

The following command saves informational messages from all modules in

a file called “sw56.log” and overwrites the file of the same name if it

already exists in the file system:

save log=permanent filename=sw56.log severity=i overwrite

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 679 680

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis AT-S63 Manuel d'utilisateur Page 263

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Allied-telesis AT-S63