Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur télécharger pdf (Page 40)

Chapter 1: Overview

Terminal Port

The terminal port is used to establish a local (out-of-band) management

session with the switch and configure the switch’s operating parameters.

You establish a local management session with the switch by connecting

a terminal or a personal computer with a terminal emulation program to

the port.

Note

You can use the AT-9400 Switch as an unmanaged switch if the

default settings of the AT-S63 Management Software are adequate

for your network. For a list of the default settings, refer to the AT-S63

Management Software Features Guide.

The terminal port has an RJ-45 style connector. An RJ-45 to RS-232

management cable is supplied with the switch.

The terminal port is set to the following specifications:

 Default baud rate: 9600 bps (Range is 9600 to 115200 bps)

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

Note

These settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulation program.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

Pas de commentaire

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur Page 40