Allied-telesis AT-8326GB Manuel d'utilisateur télécharger pdf (Page 58)

AT-8326GB Installation Guide

Powering On the Switch

1. Apply AC power to the switch by plugging the power cord into the AC

power connector on the back panel of the unit and plugging the

other end into a wall outlet.

If powering on a switch stack, power on the last slave switch in the

stack first and then each slave switch in the daisy chain hierarchy

in ascending order, ending with the master switch. To simplify the

process, you can connect all of the switches, both master and

slaves, to the same power circuit, such as a power strip, and so be

able to apply power to all of the switches at the same time.

Warning

The power cord is used as a disconnection device. To de-energize

equipment, disconnect the power cord. 10

As power is applied to the switch, the Fault LED (shown in Figure

31) flashes briefly as the switch loads its operating software. This

process takes only a minute or two. After the switch has finished

loadings its software, the Fault LED will stop flashing and remain

OFF.

Figure 31 Fault LED

Note

Refer to the section System LEDs on page 19 for information on

the system LEDs.

The switch is ready for network operations.

Note

If you do not need to change the default parameter settings of the

switch, no further installation steps are required. For the default

settings, refer to the AT-S41 Management Software User’s

Guide.

FAULT

PWR

AT-8326GB

24 + 2G Managed Switch

STACK ID

Fault LED

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 81 82

Pas de commentaire

Allied-telesis AT-8326GB Manuel d'utilisateur Page 58