Allied-telesis AT-8326GB Manuel d'utilisateur télécharger pdf (Page 44)

AT-8326GB Installation Guide

Selecting a Site for the Switch

Observe the following requirements when choosing a site for your

switch:

G If you plan to install the switch in an equipment rack, check to be

sure that the rack is safely secured and that it will not tip over.

Devices in a rack should be installed starting at the bottom, with

the heavier devices near the bottom of the rack.

G If you are installing the switch on a table, be sure that the table is

level and secure.

G The power outlet for the switch should be located near the unit

and should be easily accessible.

G The site should allow for easy access to the ports on the front of

the switch. This will make it easy for you to connect and

disconnect cables, as well as view the switch’s LEDs.

G To allow proper cooling of the switch, air flow around the unit and

through its vents on the side and rear should not be restricted.

G Do not place objects on top of the switch.

G Do not expose the switch to moisture or water.

G Make sure that the site is a dust-free environment.

G You should use dedicated power circuits or power conditioners to

supply reliable electrical power to the network devices.

G When stacking switches, a common power source such as a

power strip is recommended for all of the switches in the stack.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 81 82

Pas de commentaire

Allied-telesis AT-8326GB Manuel d'utilisateur Page 44