Allied-telesis AT-8326GB Manuel d'utilisateur télécharger pdf (Page 51)

AT-8326GB Installation Guide

3. Slide the GBIC module into one of the GBIC slots in the front of the AT-

8326GB switch. The GBIC module is completely seated in the slot

when it clicks into place.

Figure 25 Installing a GBIC Module

4. If you purchased two GBIC modules for the switch, repeat this

procedure to install the second module.

Note

In order to use a GBIC module in Port 25 or 26, you must configure

the port in the management software to operate as a GBIC port and

not as a twisted pair port. For instructions, refer to the AT-S41

Management Software User’s Guide. When you change the port

setting in the management software to GBIC, the GBIC connector

LED to the right of the GBIC slot will turn green.

RS-2

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Pas de commentaire

Allied-telesis AT-8326GB Manuel d'utilisateur Page 51