Allied-telesis AT-8326GB Manuel d'utilisateur télécharger pdf (Page 56)

AT-8326GB Installation Guide

G If you are creating a port trunk, do not connect the cables of the

trunk to the switch until you after have configured the trunk using

the switch’s management software. Connecting the trunk cables

to the switch before you have configured the software will result

in a data loop, which can adversely affect network performance.

For instructions on how to configure a port trunk, refer to the AT-

S41 Management Software User’s Guide.

2. If you installed an optional GBIC module, remove the dust cover from

the GBIC port. Store the dust cover in a safe place so that you can use

it to protect the port if you disconnect the fiber cable.

Figure 29 Removing the Dust Cover from a GBIC Module

Caution

Do not remove the dust cover if you do not intend to connect the

GBIC cable at this time. Dust contamination can adversely impact

the operations of the port.

S-232

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 81 82

Pas de commentaire

Allied-telesis AT-8326GB Manuel d'utilisateur Page 56