Allied-telesis AT-S97 Manuel d'utilisateur télécharger pdf (Page 206)

Chapter 11: Simple Network Management Protocol (SNMP) Commands

206

SNMP SET

Syntax

snmp set mgrip1=

ipaddress

mgrip2=

ipaddress

mgrip3=

ipaddress

mgrip4=

ipaddress

Get-community=

string

Set-community=

string

Trap-community=

string

Parameters

mgrip1 - mrip4 Sets the IP addresses of up to four trap receivers.

The IP addresses have to be entered in the

following format: xxx.xxx.xxx.xxx To replace a

current value without entering a new value, enter

the default value, 0.0.0.0. This parameter is

optional.

Get-community Sets the get community string. The string can be up

to 14 alphanumeric characters. The string is case

sensitive and can contain special characters,

including spaces. However, a community string with

spaces must be enclosed in double quotes (“ “). The

default value is “public.”

Set-community Sets the set community string. The string can be up

to 14 alphanumeric characters. The string is case

sensitive and can contain special characters,

including spaces. However, a community string with

spaces must be enclosed in double quotes (“ “). The

default value is “private.”

Trap-community Sets the trap community string. The string can be up

to 14 alphanumeric characters. The string is case

sensitive and can contain special characters,

including spaces. However, a community string with

spaces must be enclosed in double quotes (“ “). The

default value is “public.”

Privilege Levels

Administrator and read-write

Description

This command is used to set the SNMPv1 and SNMPv2c community

strings and to specify the IP addresses of up to four trap receivers.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 247 248

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis AT-S97 Manuel d'utilisateur Page 206

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Allied-telesis AT-S97