Allied-telesis AT-GS924M Manuel d'utilisateur télécharger pdf (Page 43)

AT-GS908M, AT-GS916M, and AT-GS924M Switches Installation Guide

Installing SFP Transceivers

To install an SFP transceiver, perform the following procedure:

Note

The transceiver can be hot-swapped; you do not need to power off

the switch to install a transceiver. However, you should always

remove the cables before removing the transceiver.

Note

You should always install the transceiver before connecting the

fiber-optic cables to it.

1. Remove the transceiver from its shipping container and store the

packaging material in a safe location.

Warning

An SFP transceiver can be damaged by static electricity. Be sure to

observe all standard electrostatic discharge (ESD) precautions,

such as wearing an antistatic wrist strap, to avoid damaging the

transceiver.

2. Remove the dust plug from an SFP slot. See Figure 12.

Figure 12. Removing the Dust Plug from an SFP Slot

3. Position the SFP transceiver with the label facing up.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

Pas de commentaire

Allied-telesis AT-GS924M Manuel d'utilisateur Page 43