3-40 SHOW SWITCH PORT AR400 Series Router Software Reference
Software Release 2.6.6
C613-03079-00 REV A
Example To display the contents of the Forwarding Database, use the command:
SHOW SWITCH FDB
Related Commands SHOW SWITCH
SHOW SWITCH PORT
Syntax SHOW SWITCH PORT[={port-list|ALL}]
where:
■ port-list is a port number, a range of port numbers (specified as n-m), or a
comma separated list of port numbers and/or ranges. Port numbers start
at 1 and end at m, where m is the highest numbered Ethernet port.
Description This command displays general information about the specified switch ports
or all switch ports (see Figure 3-11 on page 3-40 and Table 3-17 on page 3-41).
Figure 3-11: Example output from the SHOW SWITCH PORT command.
Table 3-16: Parameters in the output of the SHOW SWITCH FDB command .
Parameter Meaning
MAC Address The MAC address as learned from the source address field of a frame,
or entered as part of a static filter entry.
Port The port where the MAC address was learned.
Status Whether the entry was a static filter entry or dynamically learned; one
of “dynamic” or “static”.
Switch Port Information
---------------------------------------------------------------------------
Port ............................ 1
Description ................... To intranet hub, port 4
Status ........................ ENABLED
Link State .................... Up
UpTime ........................ 00:10:49
Configured speed/duplex ....... Autonegotiate
Actual speed/duplex ........... 100 Mbps, full duplex
Automatic MDI/MDI-X ........... Enabled
Configured MDI/MDI-X........... MDI-X
Actual MDI/MDI-X............... MDI
Broadcast rate limit .......... 128Kbps
Multicast rate limit .......... -
DLF rate limit ................ -
Flow control(s) ............... Disabled
Send tagged pkts for VLAN(s) .. vlan2 (2)
vlan3 (3)
Port-based VLAN ............... accounting (4)
Ingress Filtering ............. OFF
---------------------------------------------------------------------------
Commentaires sur ces manuels