Allied Telesis AT-S94 Guide de l'utilisateur télécharger pdf (Page 203)

Configuring Services

Page 203

Mapping CoS Values to Queues

The Configure CoS Page contains fields for classifying CoS settings to traffic queues. When configuring QoS for

stacking, note that stacking only uses three queues.

To set CoS to queue:

1. Click Services > Queuing & Scheduling. The CoS Queuing & Scheduling Page opens:

2. In the Configure Priority to Egress Queues section, select Configure CoS.

3. Click Configure. The Configure CoS Page opens:

Figure 141:Configure CoS Page

The Configure CoS Page contains the following fields:

• Restore Defaults — Restores the device factory defaults for mapping CoS tags to a forwarding queue.

• Class of Service — Specifies the CoS priority tag values, where zero is the lowest and 7 is the highest.

• Queue — Defines the traffic forwarding queue to which the CoS priority is mapped. Four traffic priority

queues are supported (1-4) for a standalone unit and three (1-3) are supported for a stackable device.

4. Modify the Queue values or select Restore Defaults.

5. Click Apply. The CoS to Queue mapping settings are saved and the device is updated.

6. Click Save Config on the menu to save the changes permanently.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 253 254

Pas de commentaire

Allied Telesis AT-S94 Guide de l'utilisateur Page 203