Allied Telesis Patch 89262-08 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 38
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8 Patch Release Note
Patch 89262-09 for Software Release 2.6.2
C613-10402-00 REV I
interface route may have been erroneously deleted by a route update. This
issue has been resolved.
The valid and preferred parameters were incorrectly added to the dynamic
set ipv6 prefix configuration. The default onlink and autonomous
parameters were also being included. This issue has been resolved.
Level 3
The counter parameter did not exist in the show igmpsnooping command.
This issue has been resolved.
An error message is now shown if the user tries to assign more than the
allowable number of traffic class (or default traffic class) entries to active
QOS policies.
When a Core port was added to a nested VLAN, its Ingress Filtering
attribute was set to be On and Acceptable Frame Type was set to be Admit
Only VLAN tagged Frames. If the port was deleted from that VLAN, its
Ingress Filtering attribute must be set to Off and Acceptable Frame Type
must be set to Admit All Frames, however, the attributes were not changed
when the port was deleted from the nested VLAN. This issue has been
resolved.
The manager prompt did not appear when using a telnet session until the
[Enter] key was pressed several times. This issue has been resolved.
An FTP server located on a private interface of a firewall with NAT enabled
may have had its ftp-data (tcp/20) source port translated to another port.
This could lead to a firewall rejecting the data packets, as they do not strictly
conform to RFC 959. This issue has been resolved, ensuring that ftp-data
packets are sent from port 20 on the firewall, even when NAT is enabled.
Fixing speed on a fibre SPF to 1000mfull in a configuration script showed
up incorrectly as 10mfull actual speed after reboot. This issue has been
resolved.
Level 4
No issues.
Enhancements
No issues.
PCR: 40619 Module: IPG Level: 2
PCR: 40589 Module: IPG Level: 3
PCR: 40603 Module: SWI, SWMX Level: 3
PCR: 40606 Module: VLAN Level: 3
PCR: 40617 Module: TTY Level: 3
PCR: 40618 Module: SWI Level: 3
PCR: 40618 Module: SWI Level: 3
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Commentaires sur ces manuels

Pas de commentaire