Allied Telesis Patch 89262-08 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 38
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4 Patch Release Note
Patch 89262-09 for Software Release 2.6.2
C613-10402-00 REV I
In some configurations using OSPF, the command reset ip could cause a
switch reboot. This issue has been resolved.
The switch would not respond to the setting of the maxqueueseverity
parameter when configuring logging. This issue has been resolved.
When two devices had two links between them (one of which was put into
a blocking state by STP) and had multicast traffic was passing between them
(the upstream device had the higher STP priority), and the link that wasn't
blocked by STP was removed, then replaced, multicast traffic would be sent
to both ports. This issue has been resolved.
The switch would not update its IP and next-hop tables correctly when
receiving an ARP for a next-hop that it had already learnt on a different
port. For example, when two connected VRRP devices changed states
between master and backup. This issue has been resolved.
Previously, when switch filters were defined, devices with matching MAC
addresses could still receive Layer 3 routed packets when connected to the
switch on ports other than the ports prescribed by the switch filter. This
issue has been resolved.
It was possible for the VRRP priority to be incorrectly decremented to 0. If
this happened on both the Master and Slave, a VRRP advertisement packet
storm occurred. This issue has been resolved.
When an uplink port was added to a private VLAN as tagged, the tagged
status was not being set correctly which was causing untagged packets to
be flooded when they should have been dropped. This issue has been
resolved.
When the firewall IDENT PROXY was disabled, the acknowledgement
number in the TCP [RST, ACK] packet was not correct. This issue has been
resolved.
PCR: 40656 Module: IPG Level: 2
PCR: 40668 Module: FFILE Level: 2
PCR: 40674 Module: PIM Level: 2
PCR: 40685 Module: SWMX Level: 2
PCR: 40690 Module: SWI, SW56 Level: 2
PCR: 40691 Module: VRRP Level: 2
PCR: 40695 Module: VLAN, SWI Level: 2
PCR: 40727 Module: IPG Level: 2
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 37 38

Commentaires sur ces manuels

Pas de commentaire