Allied Telesis AT-FS232 Guide d'installation télécharger pdf (Page 38)

Installing the Bridging Converter

9. Secure the power supply cable in the Restricted Access Area using

multiple cable ties to minimize the chance of the connections being

disturbed by casual contact with the wiring.

Warning

"Safety Hazard"- Check to see if there are any exposed copper strands

coming from the installed wires. When this installation is done correctly

there should be no exposed copper wire strands extending from the

terminal block. Any exposed wiring can conduct harmful levels of

electricity to persons touching the wires. 17

10. With the wires securely connected to both the input power connector in

the rear of the unit and the terminal block on the power adapter, plug the

power adapter to the power outlet. (Refer to “Technical Specifications” on

page 35 for power requirements.)

11. Verify that the PWR LED on the front of the unit is green. If the PWR

LED is OFF, refer to “Troubleshooting” on page 31.

12. Perform Step 7 through Step 10 on page 22 to complete the installation.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 73 74

Pas de commentaire

Allied Telesis AT-FS232 Guide d'installation Page 38