Allied-telesis x610 Series Layer 3 Manuel d'utilisateur télécharger pdf (Page 100)

Chapter 4: Cabling the Network Ports

100

Installing SFP and SFP+ Transceivers

Review the following guidelines before installing an optional SFP or SFP+

transceiver in a switch:

 A transceiver can be hot-swapped; the switch can be powered on

when you install it. However, you should always disconnect the cables

first before removing a transceiver.

 You must install the transceiver before you connect the cables to it.

 Fiber optic transceivers are dust sensitive. When a fiber optic cable is

not installed, or when you store the transceiver, always keep the plug

in the optical bores. When you do remove the plug, keep it for future

use.

 Unnecessary removal and insertion of a transceiver can lead to

premature failure.

Warning

A transceiver can be damaged by static electricity. Be sure to

observe all standard electrostatic discharge (ESD) precautions,

such as wearing an antistatic wrist strap, to avoid damaging the

device.

The procedure to install SFP and SFP+ transceivers is the same. The

following instructions describe how to install an SFP transceiver in an

x610 switch:

1. Remove the dust plug from a transceiver slot on the switch, as shown

in Figure 69.

SFP

2321

15 17 19 21R

16 18 20 22R 24R

23R

1000 / 100

STATUS

FAULT

MASTER

RPS

PWR

PRES

MSTR

L/A

CLASS

LASER PRODUC

STACK

BUSY

READY

FAULT

CONSOLE

2081

Figure 69. Removing a Dust Plug from a SFP Slot

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 127 128

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis x610 Series Layer 3 Manuel d'utilisateur Page 100

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Allied-telesis x610 Series Layer 3