Allied-telesis IE200 Series Manuel d'utilisateur télécharger pdf (Page 44)

Chapter 3: Installing the Switch on a DIN Rail or Wall Mount

AT-IE200 Series Installation Guide 44

Installing the Switch on a DIN Rail

Observe the following requirements when choosing a DIN rail site for your switch:

 The DC PSU(s) should be located near the switch and be easily accessible.

 The site should allow for easy access to the ports on the front of the switch, so that you

can easily connect and disconnect cables, and view the port LEDs.

 The site should allow for adequate air flow around the unit and through the cooling fins.

 The site should not expose the switch to moisture or water.

 The site should be a dust-free environment.

 The site should include dedicated power circuits or power conditioners to supply

reliable electrical power to the network devices.

To install the switch on the DIN rail, hook the switch’s mounting bracket onto the DIN rail and rotate the

switch down to snap it into place.

Figure 9: Attaching the switch to a DIN rail.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Pas de commentaire

Allied-telesis IE200 Series Manuel d'utilisateur Page 44