Allied-telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT Manuel d'utilisateur Page 90

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 277
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 89
Allied Telesyn AT-VIEW PLUS
DEVICE MANAGEMENT
Address Table
Displays the list of IP interfaces and their IP addresses on the router.
Route Table
Displays the IP routing table on the router.
Note - The current firmware version does not allow the user to configure the Destination
Port Number parameter. Attempting to configure this parameter will result in the error
messages: "The error occurred with 'Set' operation. Error: gen Error." or "The error
occurred with 'Set' operation. Error: bad value."
Note - The current firmware version does not allow the following parameters to be
configured:
Destination Metric 1
Destination Metric 2
Destination Metric 3
Destination Metric 4
Next Hop Address
Routing Type
Route Updated Seconds
Routing Mask
Destination Metric 5
Attempting to configure these parameters will result in the error message: "The error
occurred with 'Set' operation. Error: gen Error."
IP Statistics
Displays statistics about IP routing, including the number of IP datagrams received.
Note - The current firmware version does not allow the Forwarding Status and the Default
TTL parameters to be configured. Attempting to configure these will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
ICMP Statistics
Displays ICMP statistics.
UDP Statistics
Displays UDP statistics.
TCP Statistics
Displays TCP statistics.
Note - The current firmware version does not allow the user to configure the TCP
Connection State parameter. Attempting to configure this parameter will result in the
error message: "The error occurred with 'Set' operation. Error: bad value."
PN 613-50665-00 Rev B Page 90 of 277
Vue de la page 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 276 277

Commentaires sur ces manuels

Pas de commentaire