Allied-telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT Manuel d'utilisateur télécharger pdf (Page 42)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Note - The current firmware version allows active ports to be disabled. However, the

disabled ports' Port Link State parameter retains the value 'on-line'.

Note - Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value."

Note - Attempting to configure the Port Speed and Mode parameter of an AT-

8216FXL/SC fixed port to '10Mbps half-duplex' or '10Mbps full-duplex' will

automatically set it to '100Mbps half-duplex' or '100Mbps full-duplex' respectively.

Note - The following parameters are not applicable to the AT-8200XL Series:

• Port Transmit Pacing Configuration

• Port MDI Configuration

• Port VDSL Rate Configuration

• Port VDSL Link Mode

Spanning Tree Info

Displays the port's spanning tree parameters.

Enable

Enables the port.

Disable

Disables the port.

Port Mirroring

Displays the information about port mirroring.

PN 613-50665-00 Rev B Page 42 of 277

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 276 277

Pas de commentaire

Allied-telesis AT-VIEW PLUS 3.1 DEVICE MANAGEMENT Manuel d'utilisateur Page 42