Allied-telesis AT-S97 Manuel d'utilisateur télécharger pdf (Page 73)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide

Note the following before performing this command:

 The command does not affect power supply or fan modules.

 Resetting the chassis ends your management session. To continue

managing the unit, you must reestablish the session after the

management module has initialized its AT-S97 Management Software.

The initialization process takes approximately one minute to complete.

Note

Parameter settings that you have not saved to the active master

configuration file on the management module are discarded during

the reset. To save your changes, use the CONFIG SAVE command.

For instructions, refer to “CONFIG SAVE” on page 157.

 To reset individual modules in a chassis, refer to “SYSTEM RESET

MODULE” on page 76.

Example

This command resets a chassis with an ID number of 0:

system reset chassis id=0

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 253 254

Pas de commentaire

Allied-telesis AT-S97 Manuel d'utilisateur Page 73