Allied-telesis AT-S95 CLI Manuel d'utilisateur télécharger pdf (Page 179)

100

101

LLDP Commands

Page 179

Example

The following example displays the Link Layer Discovery Protocol (LLDP) configuration:

The following table describes the significant fields shown in the example:

show lldp med configuration

The show lldp med configuration Privileged EXEC mode command displays the LLDP MED configuration.

Syntax

show lldp med configuration [ethernet interface]

console# show lldp configuration

State: Enabled

Timer: 30 Seconds

Hold multiplier: 4

Reinit delay: 2 Seconds

Tx delay: 2 Seconds

Port State Optional TLVs Address

---- ----- ------------- -------

1/e1 RX, TX PD, SN, SD, SC 172.16.1.1

1/e2 TX PD, SN 172.16.1.1

1/e3 Disabled

Field Description

Timer Specifies how often the software sends LLDP updates.

Hold multiplier Specifies the amount of time the receiving device should hold an LLDP packet

before discarding it.

Reinit timer Specifies the minimum time an LLDP port waits before reinitializing LLDP

transmission.

Tx delay Specifies the delay between successive LLDP frame transmissions initiated by

value/status changes in the LLDP local systems MIB.

Port The port number.

State The port LLDP state.

Optional TLVs Optional TLVs that are advertised. Possible values are:

• PD – Port description

• SN – System name

• SD – System description

• SC – System capabilities

Address The management address that is advertised.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 391 392

Commentaires sur ces manuels

Pas de commentaire

Allied-telesis AT-S95 CLI Manuel d'utilisateur Page 179

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Allied-telesis AT-S95 CLI