Allied-telesis AT-MC12T Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel informatique Allied-telesis AT-MC12T. Allied Telesis AT-MC12T User Manual [en] Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
The CentreCOM
AT-MC12T
Media Converter User’s Guide
Overview
The Allied Telesyn AT-MC12T is used in addition to a transceiver
(MAU) to convert another Ethernet physical layer to 10BASE-T. It is
connected to a transceiver of the required conversion type. The
power adapter supplies power to the AT-MC12T and to the attached
transceiver.
Table 1:
Possible Media Conversion
MDI/MDI-X Switch
The MDI/MDI-X switch located on the side of the unit, is a straight-
through crossover cable selection switch. It enables the 10BASE-T
(RJ45) port to be connected to a repeater or to a DTE without using a
special crossover cable.
The default setting of the switch is MDI-X, which means you can
connect the 10BASE-T port to a workstation or to any other DTE that
uses a straight-through cable. In the MDI configuration, slide the
switch to the MDI side and you can connect the 10BASE-T port to a
repeater/hub/concentrator using a straight-through cable.
Figure 1:
Typical Configuration
Transceiver (MAU) Conversion Type
MC12T MX40F, MX55F, MX50
(10BASE-FL MAU)
UTP—Fiber Optic
MC12T MX10S
(10BASE2 MAU)
UTP—Thin Coax
10BASE-T
REPEATER
or 10BASE-T
WORKSTATION
NODE
NODE
NODE
AT-MC12T AT-MX
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Figure 1:

The CentreCOM AT-MC12T Media Converter User’s Guide Overview The Allied Telesyn AT-MC12T is used in addition to a transceiver(MAU) to convert anoth

Page 2

Table 2: RJ45 PinoutNOTE The transceiver (MAU) attached at the AUI connector must have the SQE (heartbeat) test disabled for proper operation. LED

Page 3

Electrical Safety and Installation Requirements RADIATED ENERGY U.S. Federal CommunicationsNote: This equipment has been tested and found to comply w

Page 4

Pour tous pays : Installer le matériel conformément aux normes électriques nationales et locales.Radioaaltojen häirintä EN55022 Luokka A VAROITUS:

Commentaires sur ces manuels

Pas de commentaire