Allied-telesis AT-GS950/48 Manuel d'utilisateur télécharger pdf (Page 45)

AT-GS950/48 Gigabit Ethernet WebSmart Switch Installation Guide

Connecting the

Fiber Optic

Cables

To connect a fiber optic cable to an SFP transceiver installed in the AT-

GS950/48 Gigabit Ethernet Smart switch, perform the following procedure:

Note

If you plan to configure a redundant data path, make sure that the

Spanning Tree feature is enabled via the AT-S106 Management

Software before connecting the ethernet cables for your secondary

network connections.

1. Remove the dust plug from the SFP transceiver, as shown in

Figure 14.

Figure 14. Removing the Dust Plug from the SFP

2. Connect the fiber optic cable to the SFP port, as shown in Figure 15.

Figure 15. Connecting the Fiber Optic Cable

1753

1754

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

Pas de commentaire

Allied-telesis AT-GS950/48 Manuel d'utilisateur Page 45