Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur télécharger pdf (Page 29)

AT-EN646MOD Installation Guide

Chapter 3: Enclosure Installation 29

Secure the Optical Wire

Note

It is critical that you maintain a minimum fiber bend radius of 1 in. when you route the fiber optic

cables and mount them to the enclosure with the self-adhesive wire clips.

1. Connect the optical fiber and pigtail to the back of the enclosure with adhesive clips, as shown in Figure

25.

2. Place the optical fiber over each fiber clip on the grounding plate, push it down into the clip, and twist to

retain the fiber.

3. Ensure the pigtail forms a continuous curve of the same angle through the fiber clips and where it will

plug into the iMG646MOD unit. Again, refer to Figure 25

Figure 25. Routing the Optical Wire through the Clips

4. The Enclosure is now complete and should be locked up for later Electronics installation. Refer to Figure

26.

1 2 ... 24 25 26 27 28 29 30 31 32

Pas de commentaire

Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur Page 29