Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur télécharger pdf (Page 11)

AT-EN646MOD Installation Guide

Chapter 3: Enclosure Installation 11

Mount the Enclosure

To mount the AT-EN646MOD enclosure, perform the following procedure:

1. Remove all components from the shipping package.

2. Choose an outdoor location (indoor mounting is also acceptable) for the enclosure that is close to the

power source. The enclosure must be mounted within 50 cable feet of the power supply.

3. Using the enclosure as a template, mark the three mounting holes on the wall, as shown in Figure 4, and

prepare a mounting hole in the wall for each opening.

Figure 4. Mounting Hole Locations

4. Use #8 or larger hardware (not provided) to mount the enclosure on the wall.

Make sure that the enclosure is square to the surface. If it is not, shim with washers to prevent

warping.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur Page 11