Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur télécharger pdf (Page 18)

AT-EN646MOD Installation Guide

18 Chapter 3: Enclosure Installation

Install the Ground Wire

The AT-iMG646MOD must be connected to a good earth ground.

Caution

Install all electronics equipment as per state and local ordinances.

To install the ground wire, perform the following procedure:

1. Prepare an adequate length of 14AWG stranded grounding wire for the ground connection.

2. Strip 0.25 in. of insulation from the ground wire and crimp it into a ground wire ring lug sized for a 10-32

post.

3. Remove the Kepnut from the ground wire post.

4. Secure the ground wire ring lug on the ground wire post using the Kepnut, as shown in Figure 11.

Figure 11. Lining Up the Ground Wire

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Allied-telesis AT-EN646MOD Enclosure Manuel d'utilisateur Page 18