Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur télécharger pdf (Page 62)

Chapter 4: Cabling and Powering on the Stack

Cabling the AT-StackXG Stacking Modules

Note

Allied Telesis recommends that during the initial installation you

power off the switches before you attach the stacking cables.

To connect the AT-StackXG/.5 Stacking Cables and the optional

AT-StackXG/1 Stacking Cable to the stacking modules, perform the

following procedure:

1. Remove the plastic protectors from the connectors on the

AT-StackXG/.5 Stacking Cable shipped with the stacking module.

Refer to Figure 24.

Figure 24. Removing the Plastic Protector

2. Starting with the top switch of the stack, connect the cable to either the

Stack Port 1 or Stack Port 2 on the stacking module and tighten the

two thumbscrews to secure it to the module.

Figure 25. Connecting the AT-StackXG/.5 Stacking Cable

1244

1245

-LX44CPUCVR

AT-StackXG

Stack Po

t 1

Stack Po

t 2

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 107 108

Pas de commentaire

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur Page 62