Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur télécharger pdf (Page 54)

Chapter 3: Preparing the Switches

Verifying the AT-S63 Version Number

After you have logged on, the command line interface (CLI) prompt,

shown in Figure 22, is displayed.

Figure 22. Command Line Prompt

The version number of the AT-S63 Management Software on the switch is

displayed after “AT-S63.” In the example it‘s “V4.0.0.”

Note the following:

 The management software must be version 3.0.0 or later.

 All the switches of a stack must have the same version of the

management software.

If you need to upgrade the management software on the switch, go to the

next procedure. Otherwise, go to “Assigning the Static Module ID Number

1 to the Master Switch” on page 56 if you are configuring the master

switch of “Assigning Static Module ID Numbers to the Member Switches”

on page 59 if you are configuring a member switch.

Allied Telesis Ethernet Switch AT-9424Ts/XP - AT-S63 v4.0.0

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 107 108

Pas de commentaire

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur Page 54