Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur télécharger pdf (Page 41)

AT-9400Ts Stack Installation Guide

Installing the AT-StackXG Stacking Module

This procedure contains the installation instructions for the AT-StackXG

Stacking Module. The module must be installed in all of the switches of the

stack. It is generally easier to install the module before a switch is mounted

in the equipment rack.

Note

Although the stacking module can be hot-swapped, meaning that it

can be installed while the switch is powered on, Allied Telesis

recommends that the switches be powered off during the initial

installation of the stack.

Warning

The module can be damaged by static electricity. Be sure to observe

all standard electrostatic discharge (ESD) precautions, such as

wearing an antistatic wrist strap, to avoid damaging the device.

To install the AT-StackXG Stacking Module in the switch, perform the

following procedure:

1. Remove the blank panel from the expansion slot on the back panel of

the switch by loosening the two captive screws on the panel with a

cross-head screwdriver.

Figure 9. Removing the Blank Panel from the Expansion Slot

1241

AT-LX44CPUCV

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 107 108

Pas de commentaire

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manuel d'utilisateur Page 41