Allied-telesis AT-2701 Series Adapters Manuel d'utilisateur télécharger pdf (Page 32)

Installing the Hardware

Connecting the Network Cables

The AT-2701 series network adapter card is equipped with the SC or ST

fiber optic adapter.

To connect a network cable to the adapter, perform the following

procedure:

1. Prepare a fiber optic cable with an appropriate connector to your

adapter.

Warning

The fiber optic ports contain a Class 1 laser device. When the ports

are disconnected, always cover them with the provided plug.

Exposed ports may cause skin or eye damage.

2. Remove a rubber plug from the adapter.

3. Connect one end of the cable to the adapter.

4. Connect the other end of the cable to the appropriate Ethernet network

port or fiber optic port.

Note

After the cable is properly connected at both ends, the adapter card

LED should be functional. See Table 1 on page 14 for a description

of LED operation.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 93 94

Pas de commentaire

Allied-telesis AT-2701 Series Adapters Manuel d'utilisateur Page 32