Allied-telesis ALLIEDVIEW-UM 1.6 Manuel d'utilisateur télécharger pdf (Page 86)

Allied Telesis AlliedView-UM 1.6

User's Guide

PN 613-000381 Rev B

Page 86 of 129

Upload Parameters

1. Server - This is the address for the server that contains the GUI Resource file. If the server is a TFTP

server, the server address should be specified as an IP address. If the server is an HTTP server, the

server address should be specified as a URL.

2. Destination - This sets the location where the new GUI Resource file will be stored. This can be set to

FLASH or NVS.

3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.

Device Selection

Before device selection can be performed, a GUI Resource file must be specified. After selecting a GUI

Resource file, the Available Devices list will be populated with the IP addresses of the devices to which

the specified GUI Resource file can be applied to.

Except for the above mentioned process, device selection is similar to that of the Release Upgrade

Operation pane.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 128 129

Pas de commentaire

Allied-telesis ALLIEDVIEW-UM 1.6 Manuel d'utilisateur Page 86