Allied-telesis ALLIEDVIEW-UM 1.6 Manuel d'utilisateur télécharger pdf (Page 70)

Allied Telesis AlliedView-UM 1.6

User's Guide

PN 613-000381 Rev B

Page 70 of 129

Upload Parameters

1. Server - This is the address for the server that contains the Configuration file. If the server is a TFTP

server, the server address should be specified as an IP address. If the server is an HTTP server, the

server address should be specified as a URL.

2. Destination - This sets the location where the new Configuration file will be stored. This can be set to

FLASH or NVS.

3. Protocol - This specifies the protocol that the server supports. This can be set to HTTP or TFTP.

NOTE:

The Destination field is not applicable to devices that use non-AlliedWare™ management software and will be ignored during

the Configuration File Update operation.

Since devices that use non-AlliedWare™ management software only support TFTP, the Protocol field will also be ignored but

will internally be set to "TFTP" during the Configuration File Update operation.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 128 129

Pas de commentaire

Allied-telesis ALLIEDVIEW-UM 1.6 Manuel d'utilisateur Page 70