Allied-telesis FastSwitch8 Manuel d'utilisateur télécharger pdf (Page 13)

FastSwtich8 Installation Guide

To Place a Single LanEdge Product on a Desktop

1. Place the unit upside down.

2. Locate the round rubber feet and square rubber bumpers from the

accessory bag. Remove the paper cover from the adhesive and press a

rubber foot into each round receptacle on the bottom of the unit.

Remove the paper cover from the adhesive and press a rubber bumper

into each square receptacle on the bottom of the unit.

3. Put the unit on the desktop. Skip to “Connecting the FastSwitch8” on

page 9.

To Wall Mount a LanEdge Product

Do not install the rubber feet or bumpers if you are wall mounting the product.

If you previously installed the square rubber bumpers, remove them using the

following step. (The round rubber feet need not be removed.)

1. To remove the square rubber bumper from the unit:

— Place the unit upside down. For each bumper, insert the tip of a

small straight-slot screwdriver between the rubber bumper and

the unit casing. Press down on the screwdriver to pry the bumper

off.

Now proceed with the following steps:

2. Prepare the wall by installing two screws (provided) at 9 1/4-inch

(23.5 cm) apart on center.

3. Position the unit onto the screws. Skip to “Connecting the

FastSwitch8” on page 9.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Pas de commentaire

Allied-telesis FastSwitch8 Manuel d'utilisateur Page 13